![]() ![]() there are 3 screws (must be unscrewed from behind, and then the first right OEM gauge support must be trimmed off.Īnd as seen in the picture below, the bottom center area must be trimmed to clear the gauge. you must remove the entire upper portion of the OEM gauge mounting hardware. Mounting of the gauge cluster requires trimming of the gauge surrounds. Red/yellow ~ red/blue go into blk and yellow plug Green ~ blue and yellow wire from blk plug and yellow plug NX speed sensor (S13 sensor will read double speed) (per nurvcom on Zilvia, i found this to be pretty close, but depending on the year/options/tranny of your s13, and which NX cluster year/options/tranny ) I made a pretty close guide to wire color > gauge function at this link to show how i did it. I just recently did this upgrade to my car, so i felt like sharing, ill post any additional info borrowed from zilvia, and other sites to assist in knowledge. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |